Removing and cleaning the squeegee
• Pull the suction hose from the connector.
• Lift the squeegee with your foot.
• Compress the lock springs. The
squeegee is released and can be re-
moved from the squeegee holder.
• Clean the squeegee under running water using a brush.
Notice:
Only cleaned and intact blades ensure op-
timal suction results!
Empty and clean the recovery tank and fresh water tank
Notice:
Drain water or cleaning solution must be
disposed of in compliance with the nation-
al regulations.
Notice:
When draining the recovery tank, the reg-
ulations of the detergent supplier regard-
ing personal protective equipment of the
cleaning solution manufacturer must be
observed.
Proceed as follows:
• Take the drain hose out of the holder.
• Open the red or blue cover at the level of the handle, lower
the end of the hose slowly and empty the recovery or fresh
water tank.
Cleaning the recovery tank and fresh water tank
• Open the tank lid.
• Remove the dirt sieve (yellow), emp-
ty it and thoroughly rinse it under run-
ning water.
• Remove the tank from the machine.
• Rinse the recovery tank and the fresh
water tank thoroughly with clean wa-
ter.
• Take out the suction filter (yellow)
and remove the dirt with a cloth or a
soft brush.
• Check the float to make sure it is fully
functional and repair any fault
Attention:
Clogged suction filters may impair the suc-
tion performance.
• After you have finished emptying the tanks, screw the red
and blue cover back on and hang the hose on the holder.
• Reinsert the tank into the machine.
• Reassemble the dirt sieve (yellow) and the suction filter.
Cleaning the fresh water tank filter
Clean the fresh water tank filter after the end of operation.
Clogged filters can inhibit the supply of detergents and thus
lead to surface damage.
• The machine must be switched off.
• Unscrew the fresh water tank filter
and remove it.
• Rinse the filter thoroughly with clean
water.
Notice:
The filter is lower than the drain hole of the
tank. A rest amount of cleaning solution
will run out only when the filter is removed.
• Put the filter back and twist it closed.
Removing and cleaning the brush
Notice:
Clean the brush whenever cleaning work
is completed.
• To lift the tool, push the foot pedal
downwards until it engages.
• Rotate the tool counterclockwise
away from the tool connection using
your foot.
• Clean the tool under running water.
EN
59