Specific Safety Rules - Makita HM1801 Manual De Instrucciones

ENGLISH
1 Switch lever
2 Indicator lamp
3 Bit with collar
4 Bit without coller
5 Bit
6 Tool retainer
7 Tool holder
8 When the bit is inserted
SPECIFICATIONS
Model
Blows per minute
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for heavy chiselling and demolition
work as well as for driving and compacting with appropri-
ate accessories.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
For public low-voltage distribution systems of
between 220 V and 250 V.
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavor-
able mains conditions can have adverse effects to the
operation of other equipment. With a mains impedance
equal or less than 0.32 Ohms it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protective
circuit breaker having slow tripping characteristics.
Explanation of general view
9 When the bit is retained
10 Notched portion
11 Tool retainer shaft
12 Barrel
13 Commutator
14 Insulating tip
15 Carbon brush
16 Hex wrench 5
HM1801
1,100
824 mm
30 kg

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to ham-
mer safety rules. If you use this tool unsafely or incor-
rectly, you can suffer serious personal injury.
1. Wear ear protectors. Exposure to noise can cause
2. Use auxiliary handles supplied with the tool. Loss
3. Hold tools by insulated gripping surfaces when
4. Wear a hard hat (safety helmet), safety glasses
5. Be sure the bit is secured in place before opera-
6. Under normal operation, the tool is designed to
7. In cold weather or when the tool has not been
17 Motor housing cover
18 Brush holder cap
19 Screwdriver
20 Cap
21 Wrench 23
22 Hammer grease
/II
hearing loss.
of control can cause personal injury.
performing an operation where the cutting tool
may contact hidden wiring or its own cord. Contact
with a "live" wire will make exposed metal parts of the
tool "live" and shock the operator.
and/or face shield. Ordinary eye or sun glasses
are NOT safety glasses. It is also highly recom-
mended that you wear a dust mask and thickly
padded gloves.
tion.
produce vibration. The screws can come loose
easily, causing a breakdown or accident. Check
tightness of screws carefully before operation.
used for a long time, let the tool warm up for a
while by operating it under no load. This will
loosen up the lubrication. Without proper warm-
up, hammering operation is difficult.
HM1810
1,100
824 mm
32 kg
GEB004-2
5