Mounting The Water Drain Outlet (Optional); Installing The Refrigerator; Changing The Door Hinge - Dometic COOLMATIC CRX 50 Instrucciones De Montaje Y De Uso

CRX
Condensate is produced when the refrigerator is operating normally. You can
either wipe up the condensate on the floor of the refrigerator in regular intervals,
or drain it through an outlet in the floor of the refrigerator (see chapter "Mounting
the water drain outlet (optional)" on page 21).
7.3

Mounting the water drain outlet (optional)

➤ Connect a hose with an inside diameter of 10 mm (not included) to the water
drain outlet.
➤ Lay the refrigerator on its side in order to access the bottom side.
➤ Mount the water drain outlet (fig. 9 2, page 8) aligned to the front or to the
back according to the desired outlet direction.
➤ Remove the water drain plug (fig. 9 1, page 8) inside the refrigerator.
7.4

Installing the refrigerator

Proceed as follows to install the refrigerator:
➤ If you wish to drain the condensate through a hose:
Mount the water outlet port (see chapter "Mounting the water drain outlet
(optional)" on page 21)
➤ Undo the transport lock (chapter "Releasing the lock" on page 27).
➤ Open the refrigerator door.
➤ Remove the blanking plugs (fig. 0 2, page 8).
➤ Push the refrigerator into the recess.
➤ Fix the refrigerator in place using suitable screws (fig. 0 1, page 8).
➤ Press the blanking plugs (fig. 0 2, page 8) into the openings.
7.5

Changing the door hinge

You can also change the hinge of the door, so that it opens to the left rather than the
right.
➤ Proceed as shown in fig. a, page 9 to fig. c, page 9, to change the hinges.
EN
Installing and connecting the refrigerator
21