Connecting The Camera; Checking The Function And Setting The Camera - Dometic PERFECTVIEW CAM 301 Instrucciones De Montaje Y De Uso

Connecting the camera

9 Connecting the camera
I
NOTE
Lay the camera cable so that, should you need to remove the camera, you can access
the plug connection between the camera and the extension cable easily. This simpli-
fies dismantling considerably.
➤ Guide the camera cable into the vehicle interior.
➤ Insert the camera cable plug into the socket of the monitor cable (fig. 8, page 4).
I
NOTE
•
To minimize corrosion in the plug, apply a small amount of grease, such as pin
grease, in one of the plugs.
•
Extension cables are available if needed (see chapter "Accessories" on page 9).
•
The cable plug connections are waterproof (IP67). As an option you can add a seal-
ing tape to the connections (fig. 5 B, page 3).
10

Checking the function and setting the camera

➤ Check the function of the camera after you have connected it to a monitor.
➤ If necessary adjust the camera using the monitor image:
The monitor image should show the rear or the bumper of the vehicle at the bottom edge of
the screen. The middle of the bumper should be in the middle of the screen (fig. 9, page 4).
➤ Tighten the two fastening screws of the top camera holder.
Settings for contrast and brightness can be made on the monitor.
Activating mirror function
See fig. 0 A, page 5.
Deactivating distance markers
See fig. 0 B, page 5.
14
PerfectView
EN