Vermeiren INOVYS Manual De Instrucciones página 11

GB
INOVYS
12/2008
LOCKING LEG INTO HIGH POSITION
To lock the leg support into the desired position,
tighten the screw (D) finger-tight. Before the leg
A
support can be let down, the screw (D) must first be
loosened. Only then can the leg support be adjusted
in its angle with the trigger lever (A).
ADJUSTING THE BASIC POSITION
Due to the adjustability of the wheelchair, it could be
possible that depending on the selection of wheel
D
size, seat height and seat depth, a collision may occur
between the footplates and the steering wheels. This
collision can be avoided with the adjusting screw (E)
since with this adjusting screw (E) you can determine
to what extent the leg support can be put into the
E
lowest position.
ADJUSTING THE LENGTH
In order to adjust the leg support in length, loosen the
screw (F) and put the footplate's plug-in tube into the
desired position and reinsert the screw (F). Several
holes are available to you for securing.
ADJUSTING THE FOOT ANGLE
Loosen the black knurled screw (G), put the footplate
into the desired angle and retighten the screw finger-
F
tight.
G
ADJUSTING THE DEPTH OF THE FOOTPLATES
Loosen the two screws (H) on the footplate, select the
desired depth (three positions are possible), and
retighten the screws firmly.
H
9