Beninca CP.PONY 115 Manual Del Usuario página 19

Energy saving functioning mode (ESA)
With the "ESA" energy saving function activated ,when a full opening or closing cycle is complete the control panel is in a
condition of full energetic efficiency ,reducing at the minimum the energetic consumption by taking off power supply from the
transformer and accessories.
Press the [PGM] button to access programming or if the control unit is already in the programming
1
menu, press [5] until the ESA function is displayed.
Press the [PGM] button to enter the ESA regulation.
The display shows the current value of the ESA parameter.
2
ON ESA mode activated (default)
OFF ESA mode deactivated
3 Confirm the desired value using the [PGM] key, the display shows PRG.
The control unit goes back to the ESA menu. To exit programming, press the [PGM] and [5] buttons
4
at the same time or, alternatively, remove the power supply or wait 60 seconds.
Note :The ESA function does not work when the charger is in charging mode.
The ESA function must be disabled when there is the need of keeping the accessories output always activated ,for example
when a 24Vdc keypad or any other device that needs constant power supply is linked to the control panel.
Resetting the control unit (Res)
This function annuls all settings made, taking the control unit back to the initial conditions.
It also deletes the settings of the autostart procedure.
NOTE: Any remote controls memorised in the radio receiver are not deleted.
Press the [PGM] button to access programming or if the control unit is already in the programming
1
menu, press [5] until the Res function is displayed.
2 Press and hold [PGM], the RES message starts to flash quickly.
Release the [PGM] button when the PRG message is displayed.
3
The control unit is now taken to factory values.
The control unit goes back to the RES menu. To exit programming, press the [PGM] and [5] but-
4
tons at the same time or, alternatively, remove the power supply or wait 60 seconds.
Memorising new transmitters (RADI>PP)
To memorise new transmitters with Step-by-Step function for the automation command, proceed as follows:
Press the [PGM] button to access programming or if the control unit is already in the programming
1
menu, press [5] until the Radi menu is displayed.
Press the [PGM] button to enter the Radi function.
2
The display shows the first sub-menu PP.
Press the [PGM] button to enter the PP function.
3
The display shows the PUSH message.
Press the BY transmitter button that is to be associated to the Step-by-Step function within 5
4
seconds.
5 The display shows PRG to confirm memorisation.
The control unit goes back to the RADI>PP menu. To go back to the RADI menu, press the [PGM]
6 and [5] buttons at the same time. To exit programming, press the [PGM] and [5] buttons at the
same time again or, alternatively, remove the power supply or wait 60 seconds.
ESA
PMOT
on
off
PRG
5
PGM+
RES
PMOT
PRG
5
PGM+
Radi
PMOT
PP
Push
PRG
PRG
5
PGM+
19