Setting The Temperature - Dometic CFF 35 Instrucciones De Uso

CFF35, CFF45
➤ Press the "ON/OFF" button (fig. 3 1, page 4) for between one and two sec-
onds.
✓ The LED "P" lights up (fig. 3 2, page 4).
✓ The display (fig. 3 4, page 4) switches on and shows the current temperature.
✓ The cooler starts cooling the interior.
I
NOTE – Displayed temperature
The temperature displayed is that of the large section of the interior com-
partment (fig. 9 1).
I
NOTE
When operating from a battery, the display switches off automatically if
the battery voltage is low. The LED "P" flashes orange.
Latching the cooler lid
➤ Close the lid.
➤ Press the latch (fig. 2, page 3) down, until it latches in place audibly.
I
NOTE
When latching the lid, ensure that both latch side pins are fully engaged
to ensure a good lid seal. One latch may engage slightly before the
other.
➤ If the lid is not closed equally at both sides, press until a second click
is heard.
6.6

Setting the temperature

➤ Press the "SET" button (fig. 3 5, page 4) once.
➤ Use the "UP +" (fig. 3 7, page 4) and "DOWN –" (fig. 3 6, page 4) buttons to
select the cooling temperature.
✓ The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
EN
Operation
19