Craftsman 536.888110 Operator's Manual página 24

[.,,."_o,,_ V_I Z IB]P'_"_
HOW TO REMOVE
THE SNOW HOOD
To access the spark plug, the snow
hood must be removed as follows:
1. Remove the choke control knob
(see Figure 26).
2. Remove the safety key.
3. Remove the mounting screws
(see Figure 27).
4. Slowly remove the snow hood.
Make sure that the primer button
hose and the ignition wire are not
disconnected.
5. The spark plug can now be ac-
cessed.
6. To install the snow hood, first make
sure that the primer button hose
and the ignition wire are connected.
7. Mount the snow hood to the engine
and secure with the mounting
screws (see Figure 27).
8. Connect the choke control knob
with the choke shaft on the carbure-
tor (see Figure 28 and Figure 29).
Make sure the choke control knob is
properly installed. If the choke con-
trol knob is not installed correctly,
the choke will not operate.
9. Install the safety key.
Choke
Contro
Snow Hood
Spark
Plug
Choke
Control Knob
Mounting Screws
Hose
gure 27
Figure 26
Choke Shaft
Figure 28
Safety Key
Carburetor
Figure 29
F 0410110L 24