Beko DV 1160 Manual Del Usuario página 6

B
The ventilation hose should not be
connected to the chimney of a stove or a
fireplace.
B
Do not operate your product at the same
time with heaters such as a coal or gas
stove. Airflow may cause the chimney to
flare up.
Connection to water drain (Products
with a condenser);
In products equipped with condenser unit,
water accumulated during the drying cycle
accumulates in the water tank. You should
drain accumulated water after each drying
cycle.
You can directly drain accumulated water
through the water drain hose supplied with
the product instead of periodically draining the
water collected in the water tank.
Connecting the water drain hose:
1. Pull the hose out by its end to remove it
from the product. Do not use any tools to
remove the hose. Attach the drain hose
adaptor to the end of this hose.
2. Connect the special drain hose supplied
with the product to the hose adaptor fitting.
3. Connect the other end of the drain hose
directly to the wastewater drain or to the
washbasin. The fitting must always be
secured in every type of connection. Your
house may flood if the hose comes out of
its housing during water discharge.
C
When you direct the water drain to outside,
"Water Tank" warning light will turn on at the
end of each programme.
Important:
• The hose should be attached to a height of
maximum 80 cm.
• Make sure that the hose is not pinched or
bend.
• The end of the hose should not be bent,
it should not be stepped on and it must
not be folded between the drain and the
product.
Connecting the water drain hose for
models with the water tank at the
bottom;
Connection pipe to water drain is at the
bottom rear of your machine.
1. Remove the bracket and the rubber cap.
2. Attach the drain hose and replace the
bracket to its position.
Important:
C There is no pump in the machine, so ensure
that the hose is placed to allow a easy
water flow.
C The end of the hose should never be higher
than the level of the water outlet on the
machine. Otherwise, the "tank full" light of
your machine will illuminate and stop the
programme.
6 - EN