Presetting Disc Names - Kenwood KDC-PS907 Manual De Instrucciones

Presetting Disc Names

Store the names of discs to be displayed when played.
1
Play the disc whose name you want to preset.
NOTE
• This function is not available for disc changers that do not
feature the Disc Name Preset function.
• This procedure is not to be used to store the disc and track
titles for MDs that you record.
2
Press the NAME.S button for at least two seconds.
"NAME SET" is displayed and the disc name preset mode is
entered.
The cursor blinks in the position where character input can be
made.
3
Press either the 4 or ¢ button to move the cursor to the
desired position.
The 4 button moves the cursor to the left, and the ¢
button to the right.
You can also move the cursor left or right by pressing the
+ –
TRACK or TRACK buttons, respectively, on the remote
control.
+ –
4
Press the DISC or DISC
character.
Besides the alphabet (capital letters only) and numbers, you
can choose the following characters: /,
NOTE
Direct Input
For units with KDC-C810, KDC-C710, KDC-C660 or KDC-C660C
attached, you can directly input letters using the number/letter
entry buttons on the remote.
Example: Use the following table to enter the name "DANCE".
button to display the desired
+ –
, , *, =, <, >, [ and ].
Character Button to press
"D" #3
"A" #2
"N" #6
"C" #2
"E" #3
5
Continue steps 3 and 4 until all the characters are chosen for
the name.
NOTE
You can enter up to eight characters for each name.
6
Press either the NAME.S button on the main unit or the OK
button on the remote.
The disc name is stored and the disc name preset mode is
canceled.
If you make no entry in a 10-second period, the name will be
stored with the characters input so far.
NOTE
• With the CD changer, you can only store names for up to 100
CDs (The KDC-C710, KDC-C660 and KDC-C660C disc changers
can store names for up to 50 discs.), and with the MD
changer,you can only store names for up to 30 MDs. If you
store the name for a 101st (51st) CD or 31st MD, the first name
stored for the type of disc will be erased automatically.
• Discs are identified by their total length and number of tracks. If
another disc happens to have the same specifications as one
that you have already stored a name for, the name will be
displayed for it, too.
• If you want to change the name of a disc, repeat steps 1 and 2
to display the name, and then repeat steps 3 and 4 to input the
changes.
• Pressing the RESET button does not erase the disc names
stored in a disc changer.
# Times pressed
1
1
2
3
2
27