Removing The Unit - Kenwood KDC-PS907 Manual De Instrucciones

Removing the Unit

Removing the Unit
■
1
Refer to the section "Removing the hard rubber frame" (p.34)
and then remove the hard rubber frame.
2
Remove the hex head machine screw with washer (M4×8) on
the back panel.
3
Insert the two removal tools at an angle and push them deeply
into the slots on each side, as shown.
Accessory4
4
Push downward on the left-
hand tool and the upward
on the right-hand tool, as
shown, and pull the unit
toward you until it is
halfway out. The unit may
drop if you pull it out
completely.
2CAUTION
Be careful to avoid injury from the catch pins on the removal tool.
5
Pull the unit all the way out
with your hands, being
careful not to drop it.
36
Accessory3
Removal tool