Disc Name Preset Play (Dnpp); Other Features; Audio Control Setting - Kenwood KDC-PS907 Manual De Instrucciones

Disc changer control features

Disc Name Preset Play (DNPP)

If you have preset the name of a disc that you want to listen
to in the disc changer, you can look for it by name and start
playing it.
1
Press the DNPP button on the remote.
"DNP PLAY" will appear in the display, and the disc name
preset play mode is entered.
The names of all the discs in the disc changer will appear
successively in the display for five seconds each. Discs whose
names have not been preset will appear as "NO NAME" in the
display.
NOTE
Discs in the disc changer that have never been played before will
appear as "NO ACCES" when the disc names are displayed.
When you cannot identify a disc because of the "NO ACCES"
display after inserting a disc magazine, try playing it using the
disc scan or a similar function to display the disc name.
Rapid display (forward / reverse):
+
Press the DISC or DISC
+
Pressing the DISC
names/disc titles in order.
–
Pressing the DISC
names/disc titles in reverse order.
2
When the name appears for the disc you want to play
Press the OK button.
The disc whose name is displayed will be recalled, and the disc
name preset play (DNPP) mode will end.
To cancel DNPP mode:
Press the DNPP button.
The disc name preset play (DNPP) mode will be canceled.
28
(See page 10)
Function of Remote (See page 11)
–
button.
button will rapidly display the preset
button will rapidly display the preset

Other features

(See page 10)

Audio Control Setting

Adjust various parameters of sound quality.
1
Press the AUD button to enter the control mode.
2
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will
change as follows:
Pressing the FM button advances the display, and pressing the
AM button reverses it.
• When preout is switched to unbalanced
▼
(
Bass N-F
Level
▼ ▲
Treble Fader
▼ ▲
Balance
• When preout is switched to balanced
▼
Bass Sub-preout
level
▼ ▲
Treble Balance
▲
NOTE
Source tone memory
Each source (CD, FM, AM and disc changer) has its own memory
in which to store the bass and treble tone settings.
The settings made for a particular source are recalled
automatically whenever you use that source (for example, FM
mode uses the tone settings made for FM, AM for AM, etc.).
3
Press the 4/¢ button.
Look at the table (See page 29) to adjust the mode being
displayed.
4
Press the AUD button to end the control mode.
Only when Non-fading output is
set to on
(
Only when monaural output is
set to on
)
)