Philips Sonicare FlexCare Platinum Manual De Usuario página 15

2 Place the handle on the plugged-in charger or
sanitiser.
3 Activate or deactivate Easy-start:
, To activate Easy-start: Press and hold the power
on/off button for 2 seconds. You hear 2 beeps
to indicate that the Easy-start feature has been
activated.
, To deactivate Easy-start: Press and hold the
power on/off button for 2 seconds.
You hear 1 beep to indicate that the Easy-start
feature has been deactivated.
Note: Each of the first 14 brushings must be at least
1 minute in length to properly move through
the Easy-start ramp-up cycle.
Note: Using the Easy-start feature beyond the initial
ramp-up period is not recommended and reduces
Sonicare's effectiveness in removing plaque.
Cord wrap on charger (specific types only)
If your Sonicare includes the charger cover and base,
the travel charger is pre-installed inside the cover.
1 To separate the charger cover from the charger
base, press the two gray snap bars on the charger
base and pull the white charger cover upwards.
2 Wrap excess mains cord around the gray
charger base as shown in the picture.
Be sure to wrap the cord on the inside of the
two snap levers. Guide the cord through the
small groove in the back of the charger base.
EngliSh
15