3
Place the handle on a solid surface with the
buttons facing up and lightly tap the housing
2.5cm from the bottom edge with a hammer.
4
Hold the handle upside down and push
down on the shaft to release the internal
components of the handle.
5
Insert the screwdriver under the circuit board,
next to the battery connections, and twist to
break the connections. Remove the circuit board
and pry the battery from the plastic carrier.
Guarantee and support
If you need information or support, please visit
www.philips.com/support or read the separate
worldwide guarantee leaflet.
Guarantee restrictions
The terms of the international guarantee do not
cover the following:
- Brush heads
- Damage caused by use of unauthorised
replacement parts.
- Damage caused by misuse, abuse, neglect,
alterations or unauthorised repair.
- Normal wear and tear, including chips, scratches,
abrasions, discolouration or fading.
- UV light bulb
EngliSh
21