Installation; Recommended Hand Tools; Warewasher Placement; Site Requirements - Classeq D400 Manual De Usuario

Classeq Under Counter Range - User Manual

4. Installation

Warning!
The installer and user are responsible for
ensuring the installation and operation of this
warewasher are in accordance with this manual
and with local and national regulations.
4.1

Recommended Hand Tools

The following hand tools are required when installing the
warewasher:
Spirit level

 8mm spanner
Multimeter or voltmeter

Insulated No. 2 Posi screw driver

Drill with 8mm bit

4.2

Warewasher Placement

Your warewasher should be installed on a flat, stable surface that
is capable of holding the full weight of the filled warewasher and
withstanding the vibration of regular use
20mm
Ensure there is a minimum of 10mm clearance on each side of
your warewasher and 20 mm clearance at the top of the
warewasher (►4.3).
Once your warewasher is in its final position, adjust the
adjustable feet to ensure the warewasher is stable, its weight is
being distributed equally, and it does not tilt more than 2 degrees
in any direction.
10mm
Your warewasher should be placed in a location that allows the
electrical, supply water and waste water connections to be fitted
(►4.3).
When positioning your warewasher, ensure that the water inlet,
chemical tubes and drain hoses are not kinked or squashed. Care
must also be taken to ensure the warewasher does not rest on
any of its supply hoses / leads.
4.3

Site Requirements

Overall Warewasher and Clearance Dimensions
Dimensions (mm) G350
Ware- A = 410
washer width
B = 517
depth
C = 644
height
(min)
Recess D = 430
width
E = 537
depth
F = 664
height
B
A
D400 / D400 D500 / D500
G400 DUO / G500 DUO /
G400 G500
DUO DUO
450 550 550 570
517 605 605 608
760 830 830 830
470 570 570 590
537 625 625 645
780 850 850 860
E
F
D
C
UK
7