Commissioning; Commissioning Interface; Commissioning Mode; Setting The Chemical Dosage Rate - Classeq D400 Manual De Usuario

Classeq Under Counter Range - User Manual

5. Commissioning

5.1

Commissioning Interface

Item Description
1 Exit button
2 Enter button
3 Cycle indicator
4 Fill/Heat indicator
5 Up button
6 Down button
7 Display
5.2

Commissioning Mode

With the warewasher turned on at the mains electrical supply but
off on the Control Panel, press and hold the Exit (1) and Enter (2)
buttons simultaneously for 3 seconds.
The display (7) will illuminate to show the first menu item and the
Cycle indicator (3) will illuminate red.
If no buttons are pressed for a period of time the warewasher
will cancel the Commissioning Mode and return to the off state.
Below is the complete menu list:
Display Description
Rinse aid setting (e.g. 0.5mL/L)
**
Rinse aid prime
Detergent setting (e.g. 30 = 3.0mL/L)
**
Detergent prime
Water softener setting (if fitted)
**
** The numbers indicated refer to the setting of the chemical dosing
and water hardness. For example, the default setting for rinse aid is
0.5ml of chemical per 1 litre of water; this will be displayed as 'r05'.
The default setting for detergent is 3ml of chemical per 1 litre of
water; this will be displayed as 'd30'.
5.3

Setting the Chemical Dosage Rate

Your warewasher will be set to the default chemical dosing
settings. However, since there are many different chemicals on
the market and each of these have different concentration
requirements, the dosage can be adjusted by following the
instructions given below:
Refer to the chemical bottle or contact the chemical supplier to
find the concentration requirements for the rinse aid and
detergent in millilitres of chemical per litre of water (ml/L).
Enter Commissioning Mode - press and hold the Exit (1) and
Enter (2) buttons simultaneously for 3 seconds (►5.2).
Using the Up and Down keys (5 and 6), scroll to the rinse aid
setting menu (r05), press Enter (2). The display will flash.
Use the Up and Down keys (5 and 6) to scroll to the required ml/L
setting and press Enter (2).
Using the Up and Down keys (5 and 6), scroll to the detergent
setting menu (d30), press Enter (2). The display will flash.
Use the Up and Down keys (5 and 6) to scroll to the required ml/L
setting and press Enter (2).
UK
13