Acqua Brevetti PM010 Manual De Instrucciones Para El Uso Y Mantenimiento página 17

A1.6 What's AcquaSIL 20/40
®
AcquaSIL 20/40 is a ready-to-use (do not dilute) aqueous solution of food grade sodium polyphosphates
suitable for drinking water treatment.
®
AcquaSIL 20/40 has a double protective effect: it hinders the formation of scale deposits and it prevents the
corrosion of metal components.
Anti-scaling effect: polyphosphates, even at concentration in the range of some ppm interfere with the
carbonate crystallization phenomena hindering the formation of scale deposits.
Anti-corrosive effect: polyphosphates form a protective layer on metal surfaces protecting them from possible
corrosion.
®
Keep AcquaSIL 20/40
ranging from 5 °C and 40 °C. Keep out of the reach of children.
For any further information about AcquaSIL 20/40
Technical data sheet. Ask for these documents to Acqua Brevetti S.r.l. or visit the website
www.acquabrevetti.it.
A1.7 BravaDOS performances and technical datasheet
Connections
Minimum flow rate
Peak flow rate
Min –max water hardness
Max. instantaneous heating temperature
Max temperature for stored hot water
Tank volume – refill autonomy
Min-max exercise pressure
Min-max water temperature
Min-max room temperature
o
N double serviced flats
Power supply
A1.8 Specification for water to be treated
BravaDOS has been designed for the treatment of drinking water in compliance with Directive 98/83/EC and
following modifications. If the water to be treated is not potable please contact Acqua Brevetti S.r.l.
The dosing of AcquaSIL 20/40
water treated by BravaDOS is lower than 5 mg/l. This value refers to water having a upstream of BravaDOS
a concentration of P O < 0.05 mg/l.
2 5
BravaDOS cannot be used to treat water containing chemicals of any kind (e.g. acids, bases, solvents,
detergents, antifreezes, glycols, etc.).
MAN 116
BRAVADOS - ENGLISH
®
?
in a clean place away from direct sun and heat sources with room temperature
Units
DN
lt/min
3
m /h
lt/min
3
m /h
°f
°C
3
cm – m
bar
°C
°C
N°
V-Hz-VA
®
in water increases its content of phosphorus. The P
®
please read the Material Safety Data Sheet and the
PM010 PM012
½" M ¾"M
0,5 1
0,03 0,06
25 50
1,5 3,0
500 – 22 1000 – 47
3
1 2
230 – 50/60 – 1VA
PM014 PM016
1"M 1"1/4M
2,5 2,5
0,15 0,15
75 100
4,5 6,0
5 – 35
80
60
2500 - 120 2500 - 120
1,5 - 6
5 - 30
5 - 40
3 4
O concentration in
2 5
PAG.E-4