Water Filtering - Iberspa 25414 Manual De Funcionamiento

Compact Equipment Manual for residential fitted Spas
NOTE: If no key is pressed for 25 seconds in any of the above steps, the controller will automatically
go back to indicating the temperature, without modifying the SET POINT.
Setting the calibration in the thermometer
Press the two keys simultaneously for 10 seconds and the calibration value will be displayed (0ºC by
default). Every time keys
between –20ºC and +20ºC. Press both keys simultaneously again to accept the v alue. If no key is
pressed for 25 seconds in any of the above steps, the thermometer will return to the original
temperature without modifying the calibration value.
NOTE:
For further information, consult the Thermostat Manual attached to the equipment.

4.3. WATER FILTERING

The filter is the filtering element.
selector valve should be placed in the FILTERING position for the filter to conduct the filtering
operation.
4.4. DRAINING THE SPA
The compact equipment enables the Spa to be drained by following the steps given below:
- Place the general differential switch in the OFF position.
- Place the selector valve in the DRAINING position. If a valve is installed between the equipment
and the drain, it should be open.
- To start-up suctioning, place the timer switch in the PERM position and place the general switch in
the ON position.
VERY IMPORTANT
When a few centimetres of water remain in the Spa and the pump is not suctioning water, the
pump should be switched off by placing the general switch in the OFF position. The pump may
be seriously damaged if it is left to work without water.
or are pressed, the temperature displayed will vary by 1ºC
Water passes through the sand and retains the particles.
12
English .
The