iSi Thermo XPress Whip.PLUS Manual De Instrucciones página 27

——— Refer to "Whipper data" for the required
number of chargers.
——— Only operate the device when it is
standing upright, otherwise pressure
may be lost.
6. Riser tube not inserted.
——— "Release pressure". Put the device back
into operation (see „Charging").
The content dispensed is too runny.
1. The device has been overfilled.
——— "Release pressure". Pour out the excess
content. The device is now ready for use
again.
——— Refer to "Whipper Data" for the maxi-
mum filling amount.
2. The device was not shaken enough or was not
shaken at all.
——— Adjust (increase) shaking frequency.
3. Content is not cold enough.
——— After the iSi Thermo XPress Whip plus is
filled and ready to be used, chill it in the
fridge for at least 12 hours.
4. Not enough chargers or incompatible chargers
have been used.
——— Refer to "Whipper Data" for the required
number of chargers.
——— Only use original iSi Cream Chargers.
5. Too little gelatine/other binding agent was
used.
——— "Release pressure". Additional gelatine
or other binding agents must be added
to the mixture and then it must be
poured back into the bottle.
6. The binding agent (e.g. gelatine) was not used
correctly.
——— Please follow the instructions for use for
the binding agent.
The Cream charger has not been pierced.
1. The charger used is not compatible.
——— Only use original iSi Cream Chargers.
2. The charger was inserted incorrectly.
——— Insert the charger correctly.
17
EN