Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
APPLICATIONS
○ Foam board
○ Moisture barrier / house wrap
BEFORE OPERATION
Read section titled "SAFETY" (pages 4 – 8).
Make sure of the following before operation.
WORKING ENVIRONMENT
● No fl ammable gas, liquid or other fl ammable
objects at worksite.
● Clear the area of children or unauthorized
personnel.
AIR SUPPLY
● NEVER use reactive gases or
● Never connect Stapler to pressure which
potentially exceeds 200 psi (13.7 bar
14 kgf/cm
) if a regulator fails.
2
● Never use non relieving coupler on Stapler.
1. Power source
○ Use only clean, dry, regulated compressed air as a
power source for this Stapler.
○ Air compressors used to supply compressed air to
this Stapler must comply with the requirements of
the latest version of ANSI Standard B 19.3 "Safety
Standard For Compressors For Process Industries."
○ Moisture or oil in the air compressor may accelerate
wear and corrosion in the Stapler.
Drain daily.
12
WARNING
DANGER
other
bottled
Explosion may occur.
WARNING
2. Filter-Regulator-Lubricator
○ Use a regulator with a pressure range of 0 – 120 psi
(0 – 8.3 bar 0 – 8.5 kgf/cm
○ Filter-regulator-lubricator units supply an optimum
condition for the Stapler and extend the Stapler life.
These units should always be used.
Filter .............The fi lter removes moisture and dirt
Regulator ......The regulator controls the operating
Lubricator .....The lubricator supplies an oil mist to the
gases.
Stapler
Side
3. Air hose
Compressed air supply hoses shall have a minimum
working pressure rating equal to or greater than the
pressure from the power source if a regulator fails,
or 150 psi (10.4 bar 10.6 kgf/cm
greater.
4. Air consumption
Using the Air consumption table and the Air
compressor size formula, fi nd a correct compressor
size.
Air consumption table
Operating pressure
Air consumption
).
2
mixed in compressed air.
Drain daily unless fi tted with an
automatic drain.
Keep the fi lter clean by regular
maintenance.
pressure for safe operation of the Stapler.
Inspect the regulator before operation
to be sure it operates properly.
Stapler.
Inspect the lubricator before operation
to be sure the supply of lubricant is
adequate.
Use Hitachi pneumatic tool lubricant.
Regulator
Compressor
Side
Filter
Lubricator
), whichever is
2
psi
80
(bar)
(5.5)
(6.2)
(kgf/cm
)
(5.6)
(6.3)
2
ft
/cycle
.024
.027
3
(ltr/cycle)
(.69)
(.76)
90
100
(6.9)
(7)
.030
(.85)
Publicidad
Tabla de contenido
