Removing Caps; Stapler Operation - Hitachi N 3808AP Instrucciones Y Manual De Seguridad

REMOVING CAPS

● Remove air hose
● Remove staples
(1) Gently press the cap spring up. (1)
(Use a slotted-head screwdriver or similar tool.)
Cap spring
Reverse stopper tab
Slotted-head screwdriver
(2) As you remove the curl part of the cap spring from
the cap, press the cap towards the cap magazine
avoiding contact with reverse stopper tab of the cap
rail. (2)
Cap
2
NOTE:
● Do not press the cap string too hard as a deformed
cap spring will negatively aff ect the cap sending
performance.
● If the cap rail exit becomes clogged, cut away the
excess cap.
WARNING
1
Curl part
Cap rail
exit
Cap rail

STAPLER OPERATION

Read section titled "SAFETY"(pages 4 – 8).
● Operators and others in work
area
glasses with side shields
which conforms to ANSI Z87.1
specifi cations.
Ordinary eyeglasses do not
provide adequate protection.
● Only person who have read
and understand this MANUAL
should operate the Stapler.
● NEVER point tool at yourself
or others in work area.
● Keep fi ngers AWAY from trigger when not
driving staples to avoid accidental discharge.
● Know and understand what trigger system
you are using.
Please read and understand "METHODS OF
OPERATION" found below.
● Inspect the Stapler before operating to
determine actuation system. Before starting
work, check the stapling operation switching
device.
This Hitachi stapler includes a stapling
operation switching device.
Before starting work, make sure that the
switching device is properly set.
If the switching device is not set properly, the
stapler will not operate correctly.
● Never place your hands or body closer than 8
inches (200 mm) from fi ring head when using.
● Do not drive staples into other staples;
staples can ricochet and hurt someone.
● Do not actuate Stapler unless Stapler is
placed fi rmly against the workpiece.
● In order to avoid double fi re or unwanted
ejection of a staple due to bouncing of the
Stapler.
1) do not push Stapler on workpiece with
strong force;
2) take Stapler away from workpiece using
recoil;
3) release trigger quickly when performing
trigger fi re.
English
DANGER
MUST wear
WARNING
safety
17