Franke FMYCF 906 WH Manual De Uso página 11

4. CONTROLS
L
Button Function
L Brief pressure: Light On – Medium Light – Light Off.
To change the intensity of the light in cycle, make long, separate presses on the
button. This allows variation of the light tone from "warm" to "cool".
T1
Turns the motor on/off at speed one.
Delay function:
Press and hold the button for approx. 3 seconds to Activate/Deactivate the Delay
function (automatic switching off of the Motor, the Fans and the Lighting with a
30' delay).
Cannot be enabled when Intensive or 24h are on.
T2 Turns the Motor on at speed two.
Press and hold the button for approximately 5 seconds, with all the loads turned
off (Motor and Lights), to turn the Activated Charcoal Filter alarm on. The relevant
LED flashes twice to confirm.
To turn the alarm off, press the button again and hold for at least 5 seconds. The
relevant LED flashes once.
T3 Turns the Motor on at speed three.
Press and hold the button for approximately 3 seconds, with all the loads turned off
(Motor and Lights), to perform a reset. The LED S1 flashes three times.
T4 Turns the Motor on at INTENSIVE Speed.
This speed is timed to run for 6 minutes. At the end of this time, the system
returns automatically to the speed that was set before. If it is activated with the
motor turned off, the hood will switch to OFF at the end of the time. To deactivate
it, press button T4 once more or press button T1.
Press and hold for 5 seconds to enable the remote control, indicated by the LED
flashing twice.
Press and hold for 5 seconds to disable the remote control, indicated by the LED
flashing just once.
S1 Signals the Metal Grease Filter saturation alarm, indicating that it is necessary to
wash the filters. The alarm is triggered after the Hood has been in operation for
100 working hours.
When this is activated, it signals the Activated Charcoal Filter saturation alarm,
indicating that the filter must be changed; the Metal Grease Filters must also be
washed. The Activated Charcoal Filter saturation alarm comes into operation after
the Hood has been working for 200 hours.
T1 T2 T3 T4
S1
Led
-
-
Fixed.
Flashing.
Fixed.
-
Fixed.
-
Fixed.
Fixed.
Flashing.
11