ACCESSORIES
The following accessories and more are available:
Ice Maker Kits* (Be prepared to specify refrigerator model when ordering)
•
* Excludes Non-Ice Maker Ready models
Freezer shelving
•
Replacement light bulbs
•
Replacement door logo badge
•
Plugs for door handle screw holes
•
To order accessories, call 1-877-337-3639 or visit us at www.haieramerica.com/support.
REVERSING THE DOORS
DOOR REMOVAL/REVERSAL
NOTE: Fastener heads may vary depending on model.
1. Remove front grille (if already installed)
2. Remove top hinge cover and top hinge. Lift freezer door off center hinge
and set aside
3. Unscrew center hinge pin. Be sure to retain plastic washer(s) for
reinstallation. Remove refrigerator door from bottom hinge and set
aside.
4. Use either a wrench or T25 Torx screwdriver to remove center hinge and
plastic spacer(s) by unscrewing center bolt, loosening side bolts and
sliding hinge to the center of the cabinet. Tighten bolts.
5. Remove the center bolt on the opposite side, loosen side bolts and slide
center hinge and spacers behind side bolts. Reinstall center bolt and
tighten side bolts.
6. Remove bottom hinge bolts and relocate bottom hinge to the opposite
side of the cabinet. Tighten bolts.
7. Unscrew bottom hinge pin, move to other hinge hole and tighten.
8. Relocate door stops (bottoms of both doors), hinge hole covers and
handle screw plugs (if reversing doors) on both doors to the opposite side
of the doors.
9. Place refrigerator door on bottom hinge pin. Align hinge hole in door with
hole in center hinge. Insert center hinge pin and tighten.
10. Place freezer door on center hinge pin and close.
11. Insert top hinge pin into hinge hole in top of freezer door. Align with bolt
holes in top of cabinet and tighten bolts. Replace top hinge cover.
12. Flip over front grille and reinstall.
13. See door handle instructions to remove and reinstall handles.
PAGE 7 ● SET UP & USE
Top Hinge
Door Hinge Hole
Center Hinge
Handle screw plugs
Bottom Hinge
Door Stop