Cleaning And Maintenance - WMF KÜCHENminis Standmixer, 0,8l Instrucciones De Uso

turn the locking screw (6) anti-clockwise.
Note: To ensure the tightness of the glass jug (3), the blade unit (5) must be
screwed on tightly. The blade unit (5) is easier to tighten if you apply a few drops
of cooking oil on the sealing side of the glass jug (see the figure).

Cleaning and maintenance

Remove the mains plug after use. Under no circumstances should you immerse
the drive unit (8) in water. Simply wipe the outside with a damp cloth. Do not
use any abrasive cleaning agents. Ensure that you do not injure yourself on the
sharp blade when cleaning the glass jug (3). Immediately after blending, fill
the jug with warm rinsing water and allow the motor to run for a few seconds.
Then remove the glass jug (3) and clean with a washing-up brush. For thorough
cleaning, you can disassemble the glass jug as described in the section entitled
"Disassembling the glass jug".
For quick and easy cleaning, you can place all loose parts in the dishwasher.
Dishwasher safe
Closing cap (1)
Lid (2)
Glass jug with
base (3)
Sealing ring (4)
Blade unit (5)
Locking screw (6)
Drive unit (7)
14
Can be rinsed Wipe with a
under running damp cloth
water
For UK use only
▪ This product is supplied with a 13 A plug conforming to BS 1363 fitted to the
mains lead. If the plug is unsuitable for your socket outlets or needs to be
replaced, please note the following. If the plug is a non-rewireable one, cut
it from the mains lead and immediately dispose of it. Never insert it into a
socket outlet as there is a very great risk of an electric shock.
▪ The replacement of the plug at the mains lead has to be done according to the
following instructions:
Important: The wires in this mains lead are coloured in accordance with the
following code:
blue Neutral
brown Live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
⋅ the wire which is coloured blue must be connected to the terminal which
is marked with the letter N or coloured black,
⋅ the wire which is coloured brown must be connected to the terminal
which is marked with the letter L or coloured red.
Do not connect any wire to the terminal which is marked
with the letter E or by the earth symbol , or coloured green or green and
yellow.
▪ If a 13 A (BS 1363) plug is used it must be fitted with a 3 A fuse conforming
to BS 1362 and be ASTA approved. If any other type of plug is used, the
appliance must be protected by a 5 A fuse either in the plug or adapter or at
the distribution board.
If in doubt - consult a qualified electrician.
▪ Never use the plug without closing the fuse cover.
The device complies with the European Directives 2014/35/EG, 2014/30/EG and
2009/125/EG.
At the end of its service life, this product may not be disposed of in the normal
household waste, but rather must be disposed of at a collection point for recy-
cling electrical and electronic devices. The materials are recyclable according to
their labelling. You make an important contribution to protecting our environ-
ment by reusing, recycling or utilising old devices in other ways. Please ask the
municipal administration where the appropriate disposal facility is located.
Subject to change.
15