Mounting The Inverter; Connecting The Inverter; General Instructions - Dometic SINEPOWER MSI 2312T Instrucciones De Montaje Y De Uso

SinePower
8.3

Mounting the inverter

➤ Hold the inverter against the installation location and mark the fastening points
(fig. 3 A, page 4).
➤ Attach the inverter using your chosen fastening method (fig. 3 B, page 4).
9

Connecting the inverter

9.1

General instructions

!
WARNING!
• The inverter may only be connected by a qualified workshop. The
following information is intended for technicians who are familiar
with the guidelines and safety precautions to be applied.
• Never use the inverter on vehicles where the positive terminal of the
battery is connected to the chassis.
• If you do not fit a fuse to the positive cable, the cables can over-
load, which might result in a fire.
• When installed in vehicles or boats, the inverter must be connected to the chassis
or earth.
• When setting up a socket distribution circuit (mains setup), comply with the appli-
cable regulations.
• Only use copper cables.
• Keep the cables as short as possible (< 1 m).
• Keep to the specified cable cross section and fit a cable fuse (fig. 4 3, page 4)
as close to the battery as possible on the positive cable (see the table).
Device
MSI2312T
MSI2324T
MSI3512T
MSI3524T
EN
Required cable
cross section
70 mm²
50 mm²
95 mm²
70 mm²
Connecting the inverter
Cable fuse
350 A
175 A
400 A
200 A
17