Kygo E7/1000 Guia Del Usuario página 8

E N G L I S H
True Wireless Pairing
M E T H O D 1: Pick up the two headsets from the charging base to power on and
wait for 10 seconds. The two headsets will now enter auto-pairing mode and
connect with each other after a few seconds. The headset (R) will blink red and
blue and prompt "pairing". Then open the device's Bluetooth configurations and
select "KYGO E7/1000 – R".
M E T H O D 2 :
On OFF state, press both MFB buttons for 2 seconds to power on
and wait for 10 seconds. The two headsets will now enter auto-pairing mode and
connect with each other after a few seconds. The headset (R) will blink red and
blue and prompt "pairing". Then open the device's Bluetooth configurations and
select "KYGO E7/1000 – R".
After the headset is successfully paired through method 1 or 2, the right headset
prompts "pairing connected – device connected".
14
E N G L I S H
Reconnect
M E T H O D 1:
(if the headset was placed in the case without being turned off): Pick
up the headsets from the charging base to power on -> After a few seconds the
two headsets will automatically connect with each other -> the headset will pair
automatically with the most recently paired device within Bluetooth reach.
METHOD 2: (if the headset was turned off with the MFB before being put in
the case): Press and hold the MFB buttons for 2 seconds to power on -> After
a few seconds the two headsets will automatically connect with each other ->
the headset will pair automatically with the most recently paired device within
Bluetooth reach.
Note: When reconnecting the headset it will prompt "connected", "left channel"
and "right channel". When it successfully connects to a device, the right headset
prompts "device connected".
1 5