STERWINS 20VPHT2-44.1 Instrucciones De Montaje página 303

If the product is dropped, suff ers heavy impact or begins to
vibrate abnormally, immediately stop the product and
inspect for damage or identify the cause of the vibration. Any
damage should be properly repaired or replace by an
authorized service centre.
• To reduce the risk of injury associated with contacting rotating parts, always stop the
machine, remove the battery pack, and make sure all moving parts have stopped:
- before cleaning or clearing a blockage
- when leaving the product unattended
- before installing or removing attachments
- before checking, maintaining or working on the product
- if the machine starts to vibrate abnormally (inspect immediately)
Cutting tips
1. Do not force the pole hedge trimmer through heavy shrubbery. This can cause the blades to bind and
slow down. If the blades slow down, reduce the pace.
2. Do not attempt to cut stems or twigs that are larger than 1/2 inch thick or those obviously too large to
feed into the cutting blade. Use a hand saw or pruning saw to trim large stems.
3. If blades do become jammed, stop the motor, allow the blades to stop and remove the battery pack
before attempting to remove the obstruction.
4. Wear gloves when trimming thorny or prickly growth. When trimming new growth, use a wide
sweeping action, so that the stems are fed directly into the cutting blade. Older growth will have thicker
stems and will be trimmed easiest by using a sawing movement.
WARNING : Always hold the pole hedge trimmer with both
hands. Never hold shrubs with one hand and operate pole
hedge trimmer with the other. Failure to follow this warning
can result in serious injury.
WARNING : Clear the area to be cut before each use. Remove
all objects such as cables, lights, wire, or loose string which
can become entangled in the cutting blade and create a risk
of serious injury.
NOTE : While trimming, the cutting device may be blocked. So
the product will turn off automatically due to over current.
Therefore release the on/off switch and then start again to go
on with trimming.
Removing and charging the battery : Illustration 6.1 and battery instruction manual
1. Press the lock button on the top center of the battery to slide it out of the product.
2. Place the battery pack into the charger by sliding it into a locked position until it clicks
3. When the green light is fl ashing, the battery is charging. If the green light is no longer fl ashing, the
battery is fully charged.
303
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
BR
EN