Waeco PerfectCharge IU152A Instrucciones De Montaje página 45

PerfectCharge
Observe the following safety instruction for the electrical connections:
NOTICE! Risk of short circuit
A
 Always use sockets which are grounded and secured by resid-
ual current circuit breakers.
 If you have to feed cables through metal walls or other walls with
sharp edges, use ducts or tubes to prevent damage.
 Do not lay cables which are loose or bent next to electrically
conductive material (metal).
 Fasten the cables securely.
 Do not pull on the cables.
 Do not lay the 230 V mains cable and the 12/24 V DC cable in
the same duct.
 Lay the cables so that they cannot be tripped over or damaged.
9.1 Connecting the IU0U automatic charger to a battery
(fig. 8, page 7)
WARNING!
!
 Avoid coming into contact with the battery fluid.
 Batteries with a cell short circuit may not be charged, as explo-
sive gases may form due to overheating of the battery.
NOTICE!
A
Loose connections may cause overheating.
Tighten the screws on the terminals to a torque of 12 – 13 Nm.
NOTE
I
 IU152A: To connect starter batteries, use the special "START
BATT +" terminal intended for this purpose.
 IU154A, IU252A: To connect starter batteries, use the special
"BATT 1+" terminal intended for this purpose.
You will find the circuit diagrams with all possible wiring options for the vari-
ous IU0U automatic chargers in fig. 9, page 7 to fig. c, page 9.
EN
Connecting the IU0U automatic charger
45