Noise And Vibration Information - Festool HL 850 E Manual De Instrucciones Original

2.3

Noise and vibration information

The typical values determined in accordance with
EN 62841 are:
Sound-pressure level
Sound-power level
Measuring uncertainty allowance
Wear ear protection!
Overall vibration levels (Vector sum for three di-
rections)measured in accordance with EN 62841:
Vibration emission level (3 directions):
Uncertainty
The specifi ed emissions values (Vibration, noise):
– are used to compare machines.
– They are also used for making preliminary
estimates regarding vibration and noise loads
during operation.
– They represent the primary applications of the
power tool.
CAUTION
The emission values may deviate from
the specifi ed values. This is dependent
on how the tool is used and the type of
workpiece being machined.
- The actual load during the entire operating
cycle must be evaluated.
- Depending on the actual load, suitable
protective measures must be defi ned in
order to protect the operator.
3 Power supply and start-up
The mains voltage must correspond to
the specifi cation on the rating plate.
To switch on, fi rst press the switch lock [1-1] and
then the switch [1-2] (press = ON, release = OFF).
4 Electronics
The tool has full-wave electronics with
the following features:
Smooth start-up
The smooth start-up ensures the router starts
up jolt-free.
Constant speed
The pre-selected speed remains constant whether
the machine is in operation or in neutral position.
Brake (HL 850 EB)
After switching-off, the tool is electronically
brought to a standstill in 1.5 – 2 seconds.
84 dB(A)
95 dB(A) 5
K = 3 dB
5.1
- Open the lock [3-1] by pressing to the rear.
- Set the chip thickness by turning the handle
a < 2,5 m/s² [3-2]. The scale [3-3] indicates the set chip
h
K = 1,5 m/s² thickness.
- Close the lock [3-1] by pressing to the front to
lock the set chip thickness.
The max. planing depth is 3.5 mm. So as no to
overload the machine, we recommend that a
maximum planing depth of 2.5 mm be set with a
plane width > 40 mm.
By turning the handle beyond the 0 mm marking,
you reach position P = Park position. In position P,
the planer head cutter is pulled back completely
behind the planer platen. Important: This does
not apply to the rustic planer heads.
5.2
The planer is equipped with planer head HK 82 SD
as standard series. The planer head has inclined,
fi tted cutters, which is why the cutters cannot be
reground.
Changing the planer head
- Press and hold in the spindle lock [1-6].
- Use the hexagon wrench [2-7] to open the screw
[2-2].
- Pull the planer head [2-6] from the shaft.
- Clean the shaft of any deposits that may be
present.
- Mount a new planer head on the shaft.
- Secure the new planer head with the clamping
fl ange [2-4], shim [2-3] and screw [2-2]. Tighten
the screw [2-2] fi rmly.
Changing the cutters
- Use the hexagon wrench [1-4] to release the
three screws [4-1] in the planer head.
- Pull the spiral cutter [4-2] out of the planer head
at the side.
12
Machine settings
Always remove the power supply plug
from the socket before carrying out any
work on the machine.
Chip thickness adjustment
Planing head, planer blade
Use only cutters which are sharp and
undamaged. Blunt cutters increase the
danger of kick-back and reduce the plan-
ing quality obtained.