Trevi IPD 8450T Manual De Uso página 17

ENGLISH
RADIO FUNCTION
TUNING RADIO STATIONS
1. Turn on the speaker unit.
2. Press the source key (12) until TUNER is displayed on the LCD display.
3. Press TUN+ (6) on the speaker unit or iPod+/TUN+ (21) on the remote control to move forward between radio stations with a 0.05MHz
increase for each pressure. Press and hold it to automatically tune it to the following station.
4. Press TUN- (7) on the speaker unit or iPod-/TUN- (9) on the remote control to move backwards between radio stations with a 0.05MHz
decrease for each pressure. Press and hold it to automatically tune it to the previous station.
5. If you know the frequency you want to listen to, you can enter it using the numeric keypad (3) on the remote control. For instance, if
you want to listen to the radio station on 93.10 MHz, enter the numbers 9, 3, 1, and 0 in sequence. If the bandwidth is exceeded, the
ERROR message will be displayed.
6. Press the ST key (14) to switch from STEREO to MONO and vice-versa.
RADIO FREQUENCY STORAGE
1. Tune in to a radio station.
2. Press and hold the / key (4) on the speaker unit or MEM (23) on the remote control. The "P01" sign will start flashing.
3. Press the TUN+/- keys (6/7) on the speaker unit or TUN+/- (21/9) on the remote control to select where you want to store the radio
station. There are 20 available positions: from P01 to P20.
4. Press the / key (4) on the speaker unit or MEM (23) on the remote control to confirm the position.
5. Repeat steps from 2 to 4 to save the remaining positions.
6. During playback, press the / key (4) on the speaker unit or MEM (23) on the remote control to go through the stored stations.
LINE IN INPUT
The LINE IN input allows to play music from any external device with an audio output.
1. Connect the external device to the LINE IN input as described in INSTALLATION AND CONNECTIONS on page 13.
2. Turn on the speaker unit.
3. Turn on the external device.
4. Press the SOURCE key (12) until LINE is displayed.
5. Adjust volume and tones as described in BASIC OPERATION on page 13. If the volume is too low, adjust it from the external device.
AUDIO/VIDEO INPUTS - COMPOSITE VIDEO OUTPUT
By using A/V inputs you can play from any audio or audio/video source.
1. Connect the external device to the A/V inputs and a TV/Monitor to the Composite Video output as described in INSTALLATION AND
CONNECTIONS on page 13.
2. Turn on the speaker unit.
3. Turn on the external device.
4. Press the SOURCE key (12) until AV is displayed.
5. Adjust volume and tones as described in BASIC OPERATION on page 13.
6. If the external device has a video signal (e.g. a DVD player), press the VIDEO key (4) to switch to Composite Video output (Y/Pb/Pr) if
it is necessary.
NOTE
Check that the TV/monitor connected to the Composite Video output is set on the respective input. Refer to your TV/monitor's user manual.
17
IPD 8450T