Altrad BELLE TDX 650 Manual Del Operador página 14

GB
Maintenance: Every 50 hours or weekly
1. Check for the tension of Drive Belt
turn the Adjust Bolt until proper tension is achieved.
Centrifugal clutch and pump pulley.
worn out or cracked, renew the belt.
2. Adjust the clearance of Scraper
and asphalt.
3. Water Tank
using a hose
4. Sprinkler Nozzle
4a. Remove the Cap from the nozzle, and clean the inside
of Sprinkler Nozzle.
5. Moving Parts
Maintenance: Every 100 hours
1. Vibration Clutch Mechanism
works properly.
Maintenance: Every 500 hours
Use Genuine Filter element.
Maintenance: Every 800 hours
Replace the Hydraulic Oil. Flush off the tank before supplying the new Hydraulic Oil.
To vent the air in the hydraulic system, leave the Tank Cover open, and run the engine at
Adjusting The Neutral Setting Of Drive Lever
The neutral position of the Drive Lever may be shifted due to the vibration or wear of the drive cables. To adjust the Neutral Setting,
WARNING
4. Loosen the Lock Nut at the Rod End.
shifted neutral position.
7. Start the engine, and increase the engine revolution to maximum. Observe to see if the
neutral position has been properly adjusted.
position is properly set.
End, and tighten it. Then, tighten the Lock Nut at the rod end.
Do not attempt to start the engine when this nut is off its position. Machine may move suddenly and
irrationally without the capability of being controlled with the Drive Lever, which may cause severe injury or
property damage.
Servicing
DRIVE BELT
BRACKET
BOLT
BELT ADJUSTER
SPRINKLER
CAP
GREASING
POINTS
14
SCRAPER
CAP
TANK
VIBRATION
CLUTCH
V-BELT
FILTER
ELEMENT
LOCK NUT
DRAIN
PLUG