with 3 point car safety belt approved to according to ECE regulation No. 16 or equivalent
standard.
GROUP 0+ (UP TO 13 KGS)
fitting of autoplay in rearward-facing position
• The seat must be fastened in the car with an three-point belt with or without retractor,
to be approved according to ECE regulation No. 16 or equivalent standard, and it
can be placed on the front ( except cars fitted with passenger AIRBAG ) or rear
seat of the car.
• For group 0+ (up to 13 kgs) the seat must be used only in the most reclined position
(fig. 4d). never in other positions. it must be placed rearward-facing (fig. 1a). slide the
3-point waist strap trough the guides placed in the front part of the child seat frame
(fig. 2a).
NOTE: Do not pass the strap over but under the changing of position of your child
seat.
• Lock belt buckle and slide the chest strap in the back guides placed up in the back of
the child seat (fig. 3a). Both straps must be tightened to ensure maximum safety. If
the 3 point belt is too short and the buckle cannot be fastened, move the seat back as
required. Before installing the child seat you should move the car seat in the most rear
position.
• If your child´s weight is less than 9 kgs. but his mass is bigger than a stated limit, the
car seat has to be placed forward facing (Group 1).
• Buckle Position: Once fully tightened check that the seat belt buckle does not sit on
the belt guide.
• Adjustment Of The Crotch Strap: Press the adjuster and at the same time place it into
the desired position (fig. 8b). The adjuster has to be placed in the lowest position.
GROUP 1 (9 - 18 KGS)
fitting of autoplay in forward-facing position with a three-point safety belt (car
seat belt)
• Fit the child seat on the front or rear seat of the car (fig. 1b).
• Move the handle upwards as shown in fig. 2b (in both sides).
• Pass the waist strap through the guides in both sides (fig. 3b), fasten the buckle and
tighten.
• Pass the chest strap through the lock -off clip (fig. 4b) and tighten the belt.
• Lift the red button.
14