Troubleshooting; Before You Send In The Appliance; Warranty; Disposal - Dirt Devil M7004 Manual De Instrucciones

6 Troubleshooting

6.1 Before you send in the appliance

6 Troubleshooting
WARNING:
Danger of injury! Never use a defective appliance! Always switch off the
appliance and disconnect it from the mains before starting troubleshoot-
ing Chapter 4.3, "Switching off".
Before contacting us or even sending the appliance to us, use the table to
check whether you can correct the problem yourself.
Problem Possible cause / solution
Filter bag The dust filter bag is full.
change indi-
Change the dust filter bag
cator (Fig. 1/
dust filter bag".
3) appears
Nozzle, telescopic tube or suction hose is blocked.
completely in
Remove the obstruction. If necessary, use a long wood-
the display
en stick (e. g. a broomstick) to do this.
window.
The filters are dirty.
Clean the respective filter
cleaning the motor protection filter" or
"Checking and cleaning the exhaust filter".
The vacuum The overheating protection has tripped (possibly due to
cleaner blocked suction channels, filters, or similar). Switch the
stops sud- appliance off and pull the plug out of the socket. Remove
denly. the cause of overheating (e.g. by disassembling tele-
scopic tube and suction hose and removing the obstacle
and/or cleaning filters). Wait for about 45 minutes. After
the appliance has cooled off, you may switch it on again.

6.2 Warranty

The statutory warranty regulations in accordance with the EU Directive
1999/44/EC apply.

6.3 Disposal

Dispose of the appliance in compliance with the environmental
protection laws of your country. Electrical waste may not be dis-
posed of together with domestic waste. Use local old-appliance
collection points instead.
22
Chapter 5.1, "Changing the
Chapter 5.2, "Checking and
Chapter 5.3,
Problem Possible cause / solution
The cleaning The bypass vent (Fig. 1/8) is open.
results are
Close the bypass vent (Fig. 1/8).
unsatisfacto-
The attached nozzle is unsuitable.
ry in spite of
Change the nozzle,
the appli-
ance work- The position of the "carpet/hard floor" selector (Fig. 1/16)
ing correctly. is unsuitable.
Set the "carpet/hard floor" selector (Fig. 1/16) to the cor-
rect position for the type of floor,
cleaning", step 5.
The dust filter bag is full.
Change the dust filter bag
dust filter bag".
The filters are dirty.
Clean the respective filter
cleaning the motor protection filter" or
"Checking and cleaning the exhaust filter".
Nozzle, telescopic tube or suction hose is blocked.
Remove the obstruction. If necessary, use a long wood-
en stick (e. g. a broomstick) to do this.
NOTE:
If you cannot solve the problem following these instructions, contact the
Dirt Devil customer service ( Page 74, "International Service").
In non-EU countries the minimum requirements of the warranty in the re-
spective country apply.
The filters and dust filter bags are made from environmentally friendly ma-
terials. You can dispose of them — as opposed to the appliance itself —
with your domestic waste, provided they do not contain anything that is for-
bidden from disposal in domestic waste.
Chapter 3.2, "Assembly".
Chapter 4.2, "Vacuum
Chapter 5.1, "Changing the
Chapter 5.2, "Checking and
Chapter 5.3,