Tabla De Contenido - 3M ESPE Elipar FreeLight 2 Instrucciones De Manejo
Potente fotopolimerizador inalámbrico led
Ocultar thumbs
Ver también para Elipar FreeLight 2:
- Manual de instrucciones (30 páginas) ,
- Instrucciones de manejo (26 páginas)
Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Elipar
™
FreeLight
Fast-Curing Cordless LED Light
Table of Contents
Safety
from/into the Handpiece
Disposal
Customer Information
Warranty
Limitation of Liability
™
2
Page
1
2
3
3
3
3
3
3
4
4
4
4
4
4
4
4
4
5
5
5
5
5
5
6
6
6
6
6
7
7
7
7
8
8
8
8
8
8
8
8
Safety
PLEASE NOTE!
Prior to installation and start-up of the unit, please read
these instructions carefully!
As with all technical devices, the proper function and
safe operation of this unit depend on the user's
compliance with the standard safety procedures as well
as the specific safety recommendations presented in
these Operating Instructions.
1. The unit must be used in strict accordance with the
following operating instructions. The manufacturer
assumes no liability for any damage resulting from
the use of this unit for any other purpose.
2. Prior to start-up of the unit make sure that the
operating voltage stated on the rating plate is
compatible with the available mains voltage.
Operation of the unit at a different voltage may
damage the unit.
3. The light must not be aimed at the eyes in order to
avoid serious health consequences due to irradiation
of the eyes. Exposure must be restricted to the area of
the oral cavity in which clinical treatment is intended.
4. CAUTION! The Elipar FreeLight 2 unit generates high
intensity light. The light emitted should be aimed
directly above the material to be cured - exposure
of the soft tissues (gingiva, oral mucosa, and skin) to
high-intensity light should be avoided as such
exposure may cause damage or irritation. If applicable,
cover such areas. If exposure of soft tissues cannot
be avoided, adjust the polymerization process to the
light level, e.g. by shortening the polymerization
times or increasing the distance between the light
guide exit and the material to be cured.
5. Condensation resulting from the unit being trans-
ferred from a cold to a warm environment may be a
potential risk. Hence, the unit should be turned on
only after it is completely equilibrated to ambient
6. In order to avoid electric shock do not introduce any
objects into the unit with the exception of replace-
ment parts handled in accordance with the Operating
Instructions.
7. Use original 3M ESPE parts exclusively to replace
defective parts in accordance with these Operating
Instructions. The product's warranty does not cover
any damage resulting from the use of third-party
replacement parts.
8. Should you have any reason to suspect the safety of
the unit to be compromised, the unit must be taken
out of operation and labeled accordingly to prevent
third parties from inadvertently using a possibly
defective unit. Safety may be compromised, e.g. if
the unit malfunctions or is noticeably damaged.
1
Publicidad
Capítulos
Tabla de contenido
