Important Hints; Battery Safety Instructions; Operating - Medisana HS 680 Instrucciones De Manejo

3.1
The battery pack
Charging
use or after not having been used for a long time. To charge the batteries,
the battery
connect the cable of the charging unit
pack
outlet. During the charging process the charging status LED
green. When the batteries have been fully charged, the charging status
LED
unit
If you want to check the state of charge of the battery pack, disconnect
the power plug of the heat belt
off-button
for approx. 3 seconds, if the state of charge is 25 % or better. If the state
of charge is below 25 %, the charging status LED
second. You then should recharge the battery pack

IMPORTANT HINTS

• Only charge the battery pack in a dry environment at room
temperature. Never place any objects onto the battery pack.

• BATTERY SAFETY INSTRUCTIONS:

- Do not disassemble or dismantle the battery / battery pack!
Danger of explosion!
- Keep away from fire and heat sources! Danger of explosion!
-
3.2
1. Insert the battery pack
Usage
Make sure the connection socket for the power plug of the heat belt
5
through the window on the pocket on the frontside of the belt.
2. Connect the power plug of the heat belt
3. Adjust the desired temperature level (1 to 4) by pressing the on-/off-
button
one step. If level 4 is already adjusted and you press the on-/off-button
7
4. Place the heating belt around your back and abdomen and secure the
belt by fastening the Velcro. Depending on the position you put the belt
on, it warms different areas of your body.
5. If desired, you may also use the elastic support band
it around the outer side of the heat belt. This ensures an additionally
supporting effect of the belt.
needs to be charged for at least 3 hours prior to initial
6
lights up in green constantly. You now may disconnect the charging
8
from the mains and from the battery pack
1
. The charging status LED
7
Do not dispose used batteries in the household refuse;
put them in a hazardous waste container or take them to
a battery collection point, at the shop where they were
purchased!
on the battery pack is placed upwards and the LEDs can be seen
(multiply). Each press increases the temperature level by
7
again, the device will be switched off.
with the battery pack and a mains
1
from the battery pack and press the on-/
5
lights up in green constantly
8
into the integrated battery pack pocket
6
5

3 Operating

8
.
6
flashes 3 times in a
8
.
6
and the battery pack
by putting
3
GB
flashes
.
4
.
6
15