Publicidad
Idiomas disponibles
Idiomas disponibles
ICEMAKER INSTALLATION INSTRUCTIONS C
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1
PREPARE FOR INSTALLATION
• Remove the screw (A) that holds the electrical
plug cover in place. You will not need this screw
and cover.
• Remove the light shield insert (B) and discard it.
• Loosen the two mounting screws (C)
approximately 1/2" (13 mm). DO NOT REMOVE
THESE SCREWS.
C
Installation Instructions
Unplug the
Pliers
Sharp knife
B
A
Cover
removed
C
F
G
H
J
K
L
2
INSTALL FILL TUBE EXTENSION
Cut the fill tube extension
(10) to the length
(refer to the
template on page 67) with
a sharp knife or single-edge
razor blade and slide it onto
the fill tube against the stop.
3
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
4
POWER CORD ADAPTER
(on some models)
There is a power cord adapter (18) included with
the kit. Visually inspect to see if the power cord on the
icemaker matches the socket on the side wall of the
freezer compartment. If needed, secure the adapter
to the side of the icemaker power cord. When
connecting the adapter to the power cord, make sure
the seal is in place between the connectors, and ensure
that both connector locks are snapped in place. Secure
the power cord adapter to the icemaker by putting it
into the hook at the back of the icemaker and attaching
it to the icemaker with a wire tie (20).
Hook
10
or T
M
N
P
Q
R
S
C
C
10
C
(Appearance may vary)
Seal
Hole for
wire tie
Locks
Publicidad
