Publicidad
Idiomas disponibles
Idiomas disponibles
ICEMAKER INSTALLATION INSTRUCTIONS J
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator—
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION –
•
Refrigerator. To eliminate the danger
of electric shock during installation,
you must unplug the refrigerator
from its electrical outlet.
TOOLS YOU WILL NEED
Flat blade and Phillips
screwdrivers
1/4"and 5/16" Nutdriver or adjustable wrench
REMOVE ICE CUBE TRAY SHELF
1
If your refrigerator has an installed ice cube tray
shelf, use a Phillips screwdriver to remove the two
screws. Remove the ice tray shelf. Install the screws
in the back two holes until the screw heads are
about 1/2" (13 mm) from the side wall of the freezer.
If your refrigerator was not originally equipped with
an installed ice cube tray shelf, use the screws (14)
that are supplied in the kit.
Place the shelf, flat side up, in the lower basket with
the sloped end at the back.
Partially reinstall two
screws in rear two holes
Installation Instructions
Unplug the
Sharp knife
Pliers
Remove sticker
C
F
G
H
J
K
L
PREPARE THE REFRIGERATOR
2
Find the sticker located
on the back of the
refrigerator about
midway up on the right
hand side. Remove the
sticker and clear away
any foil tape from the
opening. Also remove
the sticker from the top
left corner of the freezer
compartment.
Remove the gray insulation plug that fills the hole
through the cabinet.
3
INSTALL FILL TUBE
• Cut the fill tube (16) to the
length (refer to the
on page 66) with a sharp knife
or a single-edge razor blade.
• Slide the fill tube (16) onto the
water tube inlet (15).
• Cut the fill tube extension (10) to the
(refer to the
knife or a single-edge razor blade.
• Slide the fill tube extension (10) completely over
the fill tube on the water tube inlet (15).
• On the tube side of the water
tube inlet (15) there is an
adhesive backing. Remove the
backing and slide the tube into
the hole on the back of the
refrigerator as shown. Firmly
press on the inlet to secure it.
4
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF. Leave
the power switch in the OFF position until the
refrigerator is connected to the water supply to
prevent premature operation.
Power
Switch
26
or T
M
N
P
Q
R
S
J
template
J
15
template on page 67) with a sharp
J
(Appearance may vary)
Remove
sticker
Remove
insulation plug
16
J
length
d
Hole for
wire tie
Publicidad
