Protemp PT-45-KFA Manual De Uso página 5

What's In The Box Models: 125T-KFA / 175T-KFA / 215T-KFA
Tip: Be sure to remove the axle from the side of
the Styrofoam packaging.
Tip: Use a power screwdriver and locking wrench
for easier assembly.
50 mm Screws (4)
Axle Nuts (2)
1. Insert axle through holes in wheel support.
2. Slide spacer onto axle.
3. Slide wheel onto axle and hold in place with the axle nuts.
(See Figure 1).
Wheel Support Frame
Tire
Axle Nut
4. Place heater on wheel support and line up holes on the fuel
tank lip.
5. Attach front handle with (2) long screws
(50 mm) and (2) nuts through the second hole from the front
on both sides of the tank lip and wheel support frame and
tighten firmly.
6. Insert (2) short screws (30 mm) through the first hole from the
front in the tank lip and tighten firmly. Make certain all (4)
screws are secure.
7. Attach rear handle with (2) long screws (50 mm) and (2) nuts
through the second hole from the rear of the heater on either
side. (See Figure 2)
© 2017, Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING
OR WHILE CONNECTED TO A POWER SOURCE
®
30 mm Screws (4)
Spacers (2)
Front Handle
Assembly Instructions
Models: 125T-KFA / 175T-KFA / 215T-KFA
Axle
Spacer
Figure 1
Tools Needed:
- Phillips Head Screw Driver
- 8 mm open end wrench
- 19 mm open end wrench
8 mm Nuts (8)
8. Tilt the heater up gently so it is resting on the front handle.
NOTE: DO NOT do this if there is fuel in the tank.
9. Remove the wheels to secure the second set of screws
through the rear handle.
10. Secure the rear handle with (2) short screws (30 mm) and
(2) nuts and tighten firmly
11. Replace wheels and tighten with the wheel nuts.
12. Tilt heater back down onto wheels and check all screws and
nuts to make sure they are secure.
Figure 2
Kerosene Forced Air Heater User's Manual
4
Spare Drain Plug (1)
Wheels (2)
Rear Handle
Wheel Support Frame
Axle