Machine Storage; Service And Repairs - RIDGID K-60SP Manual De Uso

NOTE! Do not tighten this set screw by driving it into the
motor.
7. While holding the set screw in place with the
hex key, tighten the jam nut (Figure 14).
Figure 14 – Tighten Jam Nut
8. Attach jaw housing to machine with socket head cap
screws.

Machine Storage

Motor-driven equipment must be kept in-
WARNING
doors or well covered in rainy weather. Store the machine
in a locked area that is out of reach of children and people
unfamiliar with drain cleaners. This machine can cause se-
rious injury in the hands of untrained users.
If machine has been exposed to freezing weather, unit
must be run for ten (10) to twenty (20) minutes without
load to warm up. Failing to do this will result in frozen bear-
ings. If machine is exposed to weather for a period of time,
moisture will form across motor windings causing motor to
burn out.
Service and Repair
WARNING
The "Maintenance Instructions" will take care of most of
the service needs of this machine. Any problems not ad-
999-997-050.10_REV. A
K-60SP Drain Cleaning Machine
dressed by this section should only be handled by an au-
thorized RIDGID service technician.
3 / "
16 Tool should be taken to a RIDGID Independent Auth -
orized Service Center or returned to the factory. All repairs
made by Ridge service facilities are warranted against de-
fects in material and workmanship.
WARNING
tical replacement parts should be used. Failure to follow
these instructions may create a risk of electrical shock or
other serious injury.
If you have any questions regarding the service or repair
of this machine, call or write to:
Ridge Tool Company
Technical Service Department
400 Clark Street
Elyria, Ohio 44035-6001
Tel: (800) 519-3456
E-mail: rtctechservices@emerson.com
For name and address of your nearest Independent
Authorized Service Center, contact the Ridge Tool Com -
pany at (800) 519-3456 or RIDGID.com
When servicing this machine, only iden-
13