Description, Specifications And Standard Equipment Description; Specifications; Standard Equipment - RIDGID K-60SP Manual De Uso

Description, Specifications and

Standard Equipment

Description
The RIDGID ® K-60SP is a portable Drain Cleaning Machine
designed to clean 1 1 / " to 4" drain lines. Applications include
4
laundry tubs, floor drains, roof vents and stack lines. Rear
handle allows for transporting up ladders and cleaning
roof-top vent stacks.
The machine is driven by a 1/2 HP motor that has a
grounded electrical system. An integral Ground Fault In -
terrupter (GFCI) is built into the line cord. A toggle switch
provides FOR/OFF/REVERSE control of the motor.
The K-60SP is designed to use sectional-type cable that
has a quick change coupling system for disconnecting
tools. The cable is manually fed in and out of the drain and
rotates at a speed of 600 RPM. The rotation of the cable
is controlled by a clutch handle. The cable stops instantly
when the clutch handle is released. An adjustment knob al-
lows the K-60SP to use both

Specifications

Line Capacity ...............Depends on choice of cable.
Refer to the following chart for
recommendations.
Recommended Line Size and Reach
Cable Size Line Size
5 / " Cable 1 1 /
8
7 / " Cable 2 - 4
8
Cable Sizes .................. 7 /
Cable Speed.................600 rpm
Motor
Type ..............................115V/60 Hz, Reversible
Rating ............................ 1 /
Amps .............................7
Weight ..........................43 lbs. (19,5 kgs.)
Dimensions:
Length ...........................18.0" (450mm)
Width .............................9.5" (240mm)
Height ............................14.0" (356mm)
Sound Pressure (L )* ......68.7 dB(A), K=3
PA
Sound Power (L )*...........76.6 dB(A), K=3
WA
* Sound measurements are measured in accordance with a standardized test per
Standard EN 62841-1.
- Sound emissions may vary due to your location and specific use of these tools.
- Daily exposure levels for sound need to be evaluated for each application and ap-
propriate safety measures taken when needed. Evaluation of exposure levels
should consider the time a tool is switched off and not in use. This may signifi-
cantly reduce the exposure level over the total working period.
999-997-050.10_REV. A
5 / " and 7 / " sectional cable.
8 8
Reach
- 4 125'
4
150'
" and 5 / " sectional
8 8
HP
2
K-60SP Drain Cleaning Machine
Standard Equipment
Model No. Description
K-60SP ..........................K-60SP Sectional Machine
115 volts/60 Hz includes:
Figure 1 – K-60SP Drain Cleaner
K-60SP-SE ....................K-60SP as above, plus:
Figure 2 – K-60SP-SE Drain Cleaner
A-1 Operator's Mitt
A-60-12 Rear Guide Hose
A-61 Tool Kit:
– T-101 Straight Auger
– T-102 Funnel Auger
– T-107 Spade Cutter
– T-125 Retrieving Auger
– T-150-1 Sharktooth Cutter
– A-3 Tool Box
– A-12 Pin Key
A-62 Cable Kit:
– Five Sections C-10,
7 / " x15' Cable
8
– A-8 Cable Carrier
5