Cleaning And Maintenance - cecotec CONGA WinDroid 980 Connected Manual De Instrucciones

ENGLISH
Fig. 15.
Stop:
When cleaning is over, the product returns to the place where cleaning started and beeps.
Remove the robot from the surface
Fig. 16.
Grab the handle and press Start/Pause for more than 5 seconds. Then, remove the product.
Turn the robot off
Fig. 17.
Move the switch button to the "O" position.
Remove the safety suction pad
Fig. 18.
Unplug the product from the power supply.
Fig. 19.
Note: when the product displays a red light and beeps, please check if the power adapter is
connected correctly. When the power adapter is correctly connected, the product will show
a blue light and will start operating. When the power adapter is connected correctly, and
the product still shows a red light, please use the direction buttons on the remote control to
operate the product and move it from its current position, until the blue light shows up, press
Start/Pause keys on the remote control for the product to operate properly.

4. CLEANING AND MAINTENANCE

When cleaning the mop cloth and the bottom parts of the product, please switch off the
product.
Clean mop cloth
Turn the robot over and remove the mop cloth, soak it in cool, clean water for 2 minutes.
Handwash with mild detergent and lay flat to dry. Let it dry completely before attaching it
again to the robot.
Do not use a wet mop cloth on the robot or it may slip on the window.
Washing the mop cloth regularly can extend its service life.
If the cloth becomes worn or no longer fits, replace it with a new one to achieve best cleaning
performance.
44
Fig. 20.
Fan cleaning
Turn the robot over and wipe any debris from the fan with a cloth to maintain suction.
Guide wheels cleaning
Turn the robot over and wipe the four side rollers with a cloth to maintain their effectiveness.
Edge Detection Sensors cleaning
Turn over the robot and wipe five edge detection sensors clean with a cloth to maintain their
effectiveness.
Fig. 21.
Squeegees cleaning
Turn over the robot and wipe five edge detection sensors clean with a cloth to maintain their
effectiveness.
Driving wheels cleaning
Before cleaning the wheels, move the power switch to the "-" position. Then wait 8 seconds
until it stops vacuuming and starts beeping. Then press the Start/Pause button key on the
remote control and start cleaning the driving wheels.
Fig. 22.
Press Start/Pause and Clean buttons on the remote control to check the driving wheels. If
there is any dust, press pause and clean the dust.
Fig. 23.
After cleaning, turn off the switch on of the bottom part to the "O" position.
Light status indicator
Blue light The product can be placed on the glass.
flashing
Steady blue Product suction is succesful. The robot remains attached to window and it
light can start cleaning the window.
Red light The robot stops suctioning so it can be removed from the window.
flashing
ENGLISH
980 CONNECTED 45