Important Safety Instructions - artograph EZ Tracer Manual Del Usuario

IMPORTANT SAFETY
INSTRUCTIONS
When using this projector, always follow basic safety
precautions:
1. Read and Understand all instructions before using.
2. Close supervision is necessary when used near children. Do not leave
unattended while in use.
3. Do not operate this equipment with a damaged cord, or if it has been dropped
or otherwise damaged, until it has been examined by a qualified electrician.
4. If an extension cord is necessary, be sure it has a suitable current rating. Cords
rated for less amperage than this equipment may overheat. Be careful to
arrange the cord so that it will not be tripped over or pulled.
5. Always unplug from the electrical outlet when not in use. Disconnect by
grasping and pulling the plug from the outlet; never yank the cord to disconnect
the plug.
6. Allow the projector to cool completely before moving. Loop the cord loosely
when storing.
7. If the projector receives water damage, do not use until inspected by a qualified
electrician.
8. To avoid electrical shock hazard, do not disassemble. Take the projector to a
qualified electrician. Incorrect reassembly can cause an electrical shock
hazard.
9. Care must be taken as burns can occur from touching hot parts
10. The projector switch is provided with the symbols 0, indicating off, and I,
indicating on.
11. Position the cord so that it will not be tripped over, pulled or come in contact
with hot surfaces.
12. Always unplug the projector from electrical outlet before cleaning, servicing and
when not in use.
13. To reduce risk of electrical shock, do not immerse this projector in water or
other liquids.
14. The use of attachments not recommended by the manufacturer may cause
the risk of fire, electric shock or injury to persons.
15. Connect this projector to a grounded outlet.
16. Disconnect the projector from power supply before replacing lamps.
17. This projector has a polarized plug (one blade is wider than the other). To
reduce the risk of electric shock, this plug is intended to fit in a polarized outlet
only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still
does not fit, contact a qualified electrician. Do not modify the plug in any way.
SAVE THESE INSTRUCTIONS