SKP Pro Audio MAX G-X SERIE Manual Del Usuario página 5

REAR PANEL 1: (MAXG 1200X/MAXG1800X/MAXG 3600X)
1 , 2. CHA Input (Balanced)
1= Ground , Pin 2 = Positive (+) , Pin3 = Negative (-).
3 , 4. 1/4" Input Socket
5. Low Cut Filter
ensures that most power can go to the middle frequencies so there is less chance for audio
clipping or make your speaker woofer damaged.
Remove range: 0 ~ 170Hz
6. Stereo / Bridge Mode Switch
Bridge mono operation is easily achieved and gives you the output power of both channels with
just one mono output. Follow these instruction for successful Bridge operation :
A> Set the Mode Switch to Bridge position while amplifier is off
B> Connect input signal
C> Connect your speaker to Bridge speakon socket (Red color) only
D> The minimum load impedance in Bridge mode is 8 ohm
E> To adjust level, use Channel A control and leave Channel B level at zero
7. Low / Mid Crossover
Range : 50 ~ 500Hz or
8. Mid / High Crossover
Range : 750 ~ 7.5kHz
9. Range Switch
~5kHz
10. Output Frequency Selector
instruction below.
A> Bypass: No limit for the output frequency. but the low frequency output still controlled by
B> High: Amplifier working at High frequency output mode, both
Low/Mid and Mid/High work as the High-pass filter, Adjustable Range : 750 ~
20kHz
C> Mid: Amplifier working at Middle frequency output mode.
Low/Mid filter works as the High-pass filter
Mid/High filter works as the Low-pass Filter
Adjustable Range : 50 ~ 7.5kHz or
D> Low : Amplifier working at Low frequency output mode, both
Low/Mid and Mid/High filter work as the Low-pass filter
Output frequency Range : 0 ~ 500Hz
Note : The setting of Low Cut Filter is always valid for all
frequency selection.
Standard XLR socket, used for all long cable runs. Please note : Pin
Connect mixer outputs for CHA and CHB
Removes ultra-low frequency from the audio signal and
Set to choose the output mode of amplifier.
Adjust the Low/Mid frequency of output
Adjust the high frequency of output
Pressed to get the adjustable frequency range of Low/Mid crossover from 500
4 modes of Bypass / High / Mid / Low available, see detail
Low Cut Filter.
500 ~ 5kHz (Range switch pressed)
500 ~ 7.5kHz (Range switch pressed)
kinds of above output
5