SKP Pro Audio MAX G-X SERIE Manual Del Usuario página 6

11. Limiter On/Off Switch
12. Grounding Post
13,14. CHA/CHB Output
designation as: 1+ , 2+ (connected) = Positive
15. Bridge Output
note the Pin designation as:
1+ , 2+ (connected) = Positive
16. Recoverable Fuse
same type, follow the Fuse instructions marked under the Recoverable Fuse housing.
17. Mains Power Cord
the selected voltage (set by the Voltage select Switch) matches your local voltage and the fuse
matches the specification marked under the Recoverable Fuse housing.
REAR PANEL 2: (MAXG 5000D)
1、 Power supply
AC230V 50Hz or AC 115V 60Hz
2、 Resettable fuse
When the amplifier malfunctions, the fuse will automatically disconnect the circuit loop; after the
trouble is removed, the fuse will automatically reset, and resume working.
3、 CHA /CHB Speakon output connector
Used by a standard Speakon connector. 1+ 2+, 1- 2-
4、 BRIDGED Speakon output connector
Used by a standard Speakon connector. 1+ 2+, 1- 2-
5、 Mode selector
For Stereo or Bridge mode selection.
6、 High Pass filter
While the switch positioned to "On"position, then the input signal under 30Hz will be cut off.
Bypass mode when the switch positioned on OFF position
7、 Auto-Limiter switch
When then switch positioned to"ON", the Auto-Limiter inside is active。
8、 CHA XLR input connector
A standard XLR socket.
Pin1: ground
9、 CHB XLR input connector
A standard XLR socket.
Pin1: ground
6
Use to choose auto-limiter function
Standard Speakon Socket for Stereo output, please note the Pin
Standard Speakon Socket with Red color, for Bridge output use only, please
When replacing the fuse, please make sure that you always use fuses of the
Before connecting the amplifier to a power outlet, please make sure that
Pin2: positive Pin3: negative。
Pin2: positive Pin3: negative。
1- , 2- (connected) = Negative
1- , 2- (connected) = Negative