Maintenance - SPARKY BBK2 1500 Instrucciones De Uso

Switch on the PRCD. Turn on switch (1). Proceed to
drill.
Control the proper position of the machine using the
built-in level (3).
WARNING: Do not touch the core bit or the
machined surface near it immediately after operation.
They may be very hot and may cause skin burns.
13. Apply gentle pressure during operation. Excessive
pressure may damage the machine or the core bit.
14. If pieces of the material are broken into the drilled
opening, take out the core bit from the material and
remove the pieces.
15. Release switch (1) to stop drilling.
1 6. Unplug the machine.
17. Close the tap and disconnect the machine from the
water feed system.
18. Remove the diamond core bit and the adapter (9).
WET DRILLING ON A DRILL STAND
1. Attach the drill stand SP 60 stationary on a solid flat
surface as described in SP 60 manual.
2. Mount the machine on the drill stand. (Read SP 60
manual.)
3. Mount a diamond core bit and tighten it gently by
hand.
4. Couple the water feed system.
5. Plug the machine into the socket.
6. Select suitable speed.
7. To switch the machine to continuous use, press
switch (1) and in pressed position lock it by button (2).
8. Using the drill stand lever slowly move the diamond
core bit to the surface and start to drill carefully.
Adjust the water feed so that steady flow of water
flushes the core bit segments.
9. Apply constant gentle pressure during operation.
Excessive pressure may damage the machine or
core bit.
10. Upon completing of work using the lever pull out the
core bit.
11. Switch off the machine.
12. Turn off the water supply.
13. Unplug the machine.
14. Remove the diamond core bit.
15. Disassemble the machine from the drill stand.
ACCESSORIES
Auxiliary handle, water feed system, adapter, set of
spanners.
Original instructions

Maintenance

WARNING: Always ensure that the tool is
switched off and unplugged before attempting to
perform inspection or maintenance.
GENERAL INSPECTION
Regularly inspect all fasteners and ensure they are
properly tightened. Should any of the screws be loose,
retighten it immediately to avoid hazards.
If the replacement of the supply cord is necessary, this
has to be done by the manufacturer or his agent in order
to avoid a safety hazard.
CLEANING
For safe operation always keep the machine and its
ventilation slots clean.
Regularly check to see if any dust or foreign matter has
entered the ventilation slots and the grills around the
switches. Use a soft brush and/or air jet to remove any
accumulated dust. Wear safety glasses to protect your
eyes whilst cleaning.
Exterior plastic parts may be cleaned with a damp cloth
and mild detergent if necessary.
WARNING: Never use alcohol, petrol or other
cleaning agent. Never use caustic agents to clean
plastic parts.
IMPORTANT! To assure product safety and reliability,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed
by certified service centres or other qualified service
organisations, always using genuine replacement parts.
9
EN