Cub Cadet LTX1046 Manual Del Usuario página 27

CAUTION:
Always use a replacement fuse with the
same amperage capacity as the blown fuse.
Tires
WARNING!
Never exceed the maximum inflation
pressure shown on the sidewall of the tire.
Refer to the tire sidewall for exact tire manufacturer's
recommended or maximum psi. Do not overinflate.
Uneven tire pressure could cause the cutting deck to mow
unevenly.
Changing the Transmission Drive Belt
Several components must be removed and special tools used in
order to change the tractor's transmission drive belt. See your
Cub Cadet dealer to have the transmission drive belt replaced.
Changing the Deck Belt on 46" Decks
WARNING!
Shut the engine off and remove
ignition key before removing the cutting blade(s) for
sharpening or replacement. Protect your hands by
using heavy gloves when grasping blades and
pulleys.
WARNING!
The V-belts found on your tractor are
specially designed to engage and disengage safely.
A substitute (non-OEM) V-belt can be dangerous by
not disengaging completely. For a proper working
machine, use factory approved belts.
All belts on your tractor are subject to wear and should be
replaced if any signs of wear are present . To change or replace
the deck belt on your tractor, proceed as follows:
1. Remove the deck as instructed earlier in this section.
2. Remove the belt covers by removing the hex screws that
fasten them to the deck. See Figure 7-8.
Hex Screws
Spindle Pulley
Deck Idler Pulley
Figure 7-8
Belt Cover
Belt Keeper
3. Loosen, but do not remove the left deck idler pulley and
belt keeper. See Figure 7-8.
4. Carefully remove the deck belt from around the two
spindle pulleys and the two deck idler pulleys. See Figure
7-8.
Changing the Deck Belt on 50" Decks
WARNING!
Shut the engine off and remove
ignition key before removing the cutting blade(s) for
sharpening or replacement. Protect your hands by
using heavy gloves when grasping blades and
pulleys.
WARNING!
The V-belts found on your tractor are
specially designed to engage and disengage safely.
A substitute (non-OEM) V-belt can be dangerous by
not disengaging completely. For a proper working
machine, use factory approved belts.
All belts on your tractor are subject to wear and should be
replaced if any signs of wear are present . To change or replace
the deck belt on your tractor, proceed as follows:
1. Remove the deck as instructed earlier in this section.
2. Remove the belt covers by removing the hex screws that
fasten them to the deck. See Figure 7-9.
Belt Keeper
Hex Screws
Belt Guard
Figure 7-9
3. Loosen, but do not remove the left deck idler pulley and
belt keeper mounted to the deck idler pulley bracket. See
Figure 7-9.
4. Carefully remove the deck belt from around the three
spindle pulleys and the two deck idler pulleys.
Deck Idler Pulleys
S 7 — S 27
ection ervice