Installing The Discharge Deflector - Snapper 7800979-00 Manual Del Operador

Installing the Discharge Deflector

WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or
service with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
1. Remove the mulching cover. See Mulching Operation .
2. Install the deflector (A, Figure 11) to the deck in place of
the mulching cover, making sure that:
• The front hole (B) on the outside front of the deflector
fits over the stud where the front of the mulching
cover was originally secured;
• The slot (C) on top of the deflector slips under the
restraining nut on top of the deck (under the right
front corner of the engine);
• The slot (D) on the inside rear of the deflector slips
onto the stud behind the rear of the discharge
opening, where the rear of the mulching cover was
originally secured.
3. Install the internal/external tooth lock washers and knob
nuts onto the studs and tighten securely.
11
WARNING
Thrown Objects Hazard
DO NOT operate without entire Grass Catcher or guard
in place. Grass Catcher components are subject to
deterioration during normal use. Inspect frequently and
replace worn or damaged components immediately.
12
Installing the Grass Bag Adapter
(Optional Accessory on Some Models)
WARNING
Amputation Hazard
• DO NOT attempt any maintenance, adjustments or
service with engine and blade running.
• STOP engine and blade.
• Disconnect spark plug wire and secure away from spark
plug.
Burn Hazard
• Engine and components are HOT.
• Avoid serious burns, allow sufficient time for all
components to cool.
1. Remove the mulching cover. See Removing the
Mulching Cover .
2. Install the adapter (A, Figure 12) to the deck in place of
the mulching cover, making sure that:
• The front hole (B) on the outside front of the adapter
fits over the stud where the front of the mulching
cover was originally secured;
• The slot (C) on top of the adapter slips under the
restraining nut on top of the deck (under the right
front corner of the engine);
• The slot (D) on the rear of the adapter slips onto the
stud behind the rear of the discharge opening, where
the rear of the mulching cover was originally secured.
3. Install the internal/external tooth lock washers and knob
nuts onto the studs and tighten securely.
4. Route the recoil rope around the outside of the rope guide
pulley (E).
Note: The recoil rope may need to be slackened. See
Starting the Mower .
www.snapper.com