Attaching The Front Handle - Snapper ESXDST82 Manual Del Usuario

EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK
„ Invert the string trimmer to access the
trimmer head.
„ Using a Phillips head screwdriver, remove
the preinstalled screws (a) from the
trimmer head.
„ Place the guard (b) on to the trimmer
head and slide the guard onto the head by
following the track on the head.
„ Align the screw holes on the guard with the
screw holes on the trimmer head.
„ Insert the screws into the trimmer head,
fastening the guard in place.
„ Place the guard cap (c) on to the guard
and slide the guard cap onto the guard.
„ Align the screw holes on the guard cap
with the screw holes on the guard.
„ Insert the screws into the guard, fastening
the the guard cap in place.
SHAFT ASSEMbLY See Figure 3.
The attachment connects to the power head
by means of a coupler device.
„ Set the unit on a flat, level surface.
„ Loosen the knob (a) on the coupler (b).
„ Push in the release button (c) located on
the lower shaft (d). Align the release button
with the positioning hole (e) and slide the two
shafts together. Rotate the lower shaft until
the button locks into the positioning hole.
„ Tighten the knob securely.
NoTE: If the button does not release
completely in the positioning hole, the shafts
are not locked into place. Slightly rotate from
side to side until the button is locked into
place.

ATTAcHING THE FRoNT HANDLE

See Figure 4.
„ Loosen the four screws (a) in the handle
with a philips screwdriver (not included)
and remove the screws from the handle.
„ Attach the front handle (b) and lower clamp
(c) on the shaft.
„ Adjust handle up or down, if necessary, to
English (original instructions)
desired operating position.
„ Tighten the four screws so that the handle
cannot be rotated on the shaft.
oPERATIoN
Do not allow familiarity with products to
make you careless. Remember that a
careless fraction of a second is sufficient to
inflict serious injury.
Always wear eye protection. Failure to do
so could result in objects being thrown
into your eyes resulting in possible serious
injury.
Never use blades, flailing devices, wire,
or rope on this product. Do not use
any attachments
recommended by the manufacturer of
this product. The use of attachments or
accessories not recommended can result in
serious personal injury.
For complete charging instructions, refer to
the Operator's Manuals for your battery pack
and charger models.
NoTE: To avoid serious personal injury,
always remove the battery pack and keep
hands clear of the lock-out button when
carrying or transporting the tool.
To INSTALL bATTERY PAcK See Figure 5.
„ Place the battery pack in the trimmer. Align
raised ribs on battery pack with grooves in
the trimmer's battery port.
„ Make sure the latch on the back of the
battery pack clicks into place and that
battery pack is fully seated and secure in
the trimmer before beginning operation.
5
wARNING
wARNING
wARNING
or accessories not