Installation; Tools And Materials; Initial Conditions And Checks; Environmental Conditions - Erreka NTS324E Manual Del Instalador

INSTALLATION

1

TOOLS AND MATERIALS

• Phillips screwdriver
• Electrician's screwdriver
• Electrician's scissors
2

INITIAL CONDITIONS AND CHECKS

Environmental conditions


Ensure the ground is firm enough to support
the strain of the barrier.

This device is not suitable for installation in
inflammable or explosive environments.
Electrical power supply installation

Ensure the power supply installation fulfils the
following requirements:
• The nominal voltage of the installation must
coincide with that of the control panel.
• The installation must be able to support the
power consumed by all the automatic key
devices.
• The installation must be earthed.
3

UNPACKING

52
Installation Manual
• Fixed wrenches (13mm, 19mm)
• Allen key 10mm
• Drill and broaches (ø3mm and ø4mm)

Check that the admissible environmental
temperature range for the device is suitable for
the location.
• The electrical installation must comply with
low voltage regulations.
• The installation elements must be properly
secured and in a good state of conservation.

If the electrical installation does not comply
with the foregoing requirements, repair before
installing the automatic key device.

The electrical cable section is indicated in: "Fig. 1
Elements of the complete installation" on page 47.
Check the content of the packages. Should it be
noticed that a piece is missing or deteriorated,
contact the nearest technical service.
R
Discard the packaging safely and in an
environmentally friendly manner.
Barrier content:
1
Barrier equipment (structure + operator +
mechanism + control board)
2
Anchor plate
3
Arm support
4
Arm support flange
5
M8 screws and nuts for arm support
6
Sheet metal screws for arms
7
Sheet metal screw for arm-flange
8
Arm caps
9
Keys
10 Instructions Manual
Other components (supplied separately):
11 Arm: ANT01 for NTS324E(M); ANT02 for
NTS424E(M); ANT04 for NTS624E(M)
12 Reflective tags (ANT08)
Other accessories (supplied separately):
ANT05 movable support for NET cylindrical bar
ANT07 anchorings for NET barrier attachment base
ANT09 skirting section for NET barrier