Maintenance - baltur BTL 4P Manual De Instrucciones

MAINTENANCE

Most components can be inspected by removing the hood. To inspect the head you must disassemble the component-carrying plate which
can be hung on hung on the burner body in two different positions to make work as practical as possible. The motor, transformer and
solenoid valve are connected via a connector while the photo-resistor is push-locked into place.
13 / 16
0006080762_201309
1) Undo the lid screw to gain access to the
interior of the burner.
2) Undo the 4 screws of the plate, as
indicated, in order to access nozzle,
electrodes and pre-heater (if fitted).
3) The plate must be hung up as illustrated
in fig. C.